Vision Systems VScom 200E PCIex Manual de usuario descargar pdf (Pagina 40)

4 Windows Driver

System Conﬁguration This panel opens when a new hardware is detected, or when the conﬁgu-

ration is explicitly opened via the control panel.

Figure 25: NT Device list

This is the basic conﬁguration panel for the VScom PCI driver in Windows NT 4.0; the lower

check-box re-enables the automatic check for new hardware. Here is the place to revoke the change

done in the detection panel.

The upper check-box enables to uninstall the drivers for already removed cards, without a complete

uninstall of the drivers. Diﬀerent from other Windows, in NT all installed drivers load and check

for there hardware. This is not eﬃcient when the hardware is removed some time ago, and causes

error messages in the event viewer. The properties of each installed VScom PCI card and its ports

are associated with the PCI slot where the card is placed. When a card is removed or displaced,

it is necessary to display the settings via this check-box. Then the board may be selected and

removed.

Card and Port Conﬁguration Open the panel as shown in ﬁgure 25. Select a VScom controller

under “VScom Cards” to gain access to the card properties. Or select an individual port under

“VScom Ports” to change its settings. The options are explained in the general sections of this

documentation.

July 2011 VScom Industrial Card User Manual 40

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 52 53

Sin comentarios

Vision Systems VScom 200E PCIex Manual de usuario Pagina 40