Vision Systems VScom 200E PCIex Manual de usuario descargar pdf (Pagina 10)

2 Introduction

Bus interface Universal PCI PCI 3.3V and 5V signals, 33 MHz

Serial Ports 2 RS 232, RS 422 plus 3 modes of RS 485

Connectors 2×DB9 male Standard for RS 232

Termination Built-In Conﬁgured for RS 422 and RS 485

BIAS Built-In Conﬁgured for RS 485 modes

Signals RS 232 RxD, TxD, RTS, CTS, DTR, DSR, DCD, RI, GND

RS 422 Rx±, Tx±, RTS±, CTS±, GND

RS 485 Full Duplex Rx±, Tx±, GND

RS 485 Half Duplex Data±, GND

Max. Bitrates 921,600 bit/s

RS 232 requires short cables with low capacity

RS 422, RS 485 921,600 bit/s

Table 3: Features of VScom 200I UPCI

The operation mode is conﬁgured via the small DIP switches according to table 9. Also resistors

for Termination and BIAS option are built-in, conﬁgured by a block of jumpers as of table 10.

There is a jumper for compatibility mode, this is used to conﬁgure the maximum bitrate of the

serial ports.

2.2.4 VScom 200I-SI UPCI

The VScom 200I UPCI card features two optical isolated serial ports, available via a classic PCI

slot. It is an optically isolated version of the VScom 200I UPCI card, the isolation is also eﬀective

in RS 232 mode.

Figure 4: VScom 200I-SI PCI

The maximum speed is 921.6 kbit/s. This can be reduced to 115,200 bit/s for compatibility issues,

using jumper JP1.

July 2011 VScom Industrial Card User Manual 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 52 53

Sin comentarios

Vision Systems VScom 200E PCIex Manual de usuario Pagina 10