Vision Systems VScom 200E PCIex Manual de usuario descargar pdf (Pagina 39)

4 Windows Driver

4.3.1 Installing in Windows NT 4.0

You need to have administrator privileges to install any new drivers under Windows NT 4.0. To

install the driver or update the conﬁguration please log on to Windows NT 4.0 as “Administrator”

or ask your system administrator to install the VScom Industrial Card and driver. Please proceed

with the following steps to install the driver:

1. Switch on the computer and start Windows NT 4.0.

2. Insert the supplied CD-ROM into the drive.

3. If your system is conﬁgured for Auto-start of CD-ROM, go to the products page, ﬁnd your

product and select driver. You’ll ﬁnd a link to the NT4 drivers directory.

4. Otherwise double click on “My Computer”, and choose your CD-ROM drive.

5. Double Click “Windows NT 4.0”.

6. Double Click “PCI_Driver”.

7. Double click “vsinst.EXE’’.

8. The Installer starts and requests conﬁrmation of installation. You may change the target

directory for the software. If there is a space in the name, please use the short name (e.g.

PROGRA~1 for “Program Files”) instead.

9. Click Yes, and Reboot when requested.

Automatic Detection of PCI Cards The system detects a new VScom Card when an Adminis-

trator logs on to Windows NT 4.0

Figure 24: NT Plug & Play

The default option is to immediately install and conﬁgure the new card. However the upper check-

box allows to delay the conﬁguration to the next logon. The lower check-box disables the check for

new hardware until explicitly enabled again.

Conﬁguration via Control Panel The installation program also adds the “VScom PCI” applet

to the Control Panel of Windows NT. Open it, to get access again to the conﬁguration panel

(ﬁgure 24).

July 2011 VScom Industrial Card User Manual 39

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 52 53

Sin comentarios

Vision Systems VScom 200E PCIex Manual de usuario Pagina 39